# Image Flasher settings: verification, speed, safety

> Choose how S.A.K. Utility verifies a flashed drive, how many drives it writes at once, when it warns about large drives, and how to clear its download caches.

Source: https://sakutility.com/wiki/image-flasher-settings
Applies to: S.A.K. Utility (SAK), a free portable Windows toolkit
Updated: 2026-11-02

To change how flashing behaves, click **Settings** at the bottom of the Image Flasher tab in S.A.K. Utility. The **Image Flasher Settings** window controls verification, write speed, the large drive warning, what happens when a flash finishes, and the cached download files.

## Steps

1. Open the **Image Flasher** tab.
2. Click **Settings**. The button is unavailable while a flash is running.

   ![Image Flasher Settings window with Verification, Performance, Safety, Behavior, and Storage groups, and OK, Cancel, and Restore Defaults buttons](https://sakutility.com/screenshots/wiki/flasher_settings.webp?v=46d79db213)

*Changes apply from the next flash*

3. Change what you need.
4. Click **OK**. To leave without saving, click **Cancel**. To reset the window's values, click **Restore Defaults**, then **OK**.

## What each setting does

### Verification

**Validation mode:** how the app checks a drive after writing.

- **Full Verification (Slowest, Most Reliable):** reads the whole image back from the drive and compares checksums. This is the default.
- **Quick Check (Faster, Less Thorough):** compares random blocks, up to 100 MB or 10 percent of the image, whichever is smaller.
- **No Verification (Fastest, No Checking):** writes and stops. The run still reports success, but nothing was checked.

### Performance

- **Buffer size:** how much data the app handles at a time, from 1 to 512 MB. It starts at 64 MB, which suits USB 3.0 drives. Larger values use more memory.
- **Max concurrent writes:** how many drives are written at the same time, from 1 to 16. The default is 1, which writes them one after another.

### Safety

- **Show large drive warning:** warns you when a selected drive is bigger than the limit below. It is on by default.
- **Large drive threshold:** the limit for that warning, from 8 to 2048 GB. The default is 128 GB.

There is no setting for the system drive. The app always refuses to flash it.

### Behavior

- **Unmount drives on completion:** ejects each drive after a successful flash, so you can remove it straight away. It is on by default.
- **Enable desktop notifications:** shows a Windows notification when a flash finishes. It is on by default.

### Storage

This group shows how much space cached Windows UUP downloads are using, or **No cached downloads found.** **Clear Download Caches** deletes them after asking you to confirm. Cancel any running download first. Use it to free space or force a fresh download.

## Good to know

- **Windows install USBs:** [Windows media](https://sakutility.com/wiki/windows-install-usb) is written a different way, so **Validation mode**, **Buffer size**, and **Max concurrent writes** do not affect it. It has its own file checks and writes one drive at a time.
- **Memory use:** each drive being written uses its own buffer, so a large buffer and many concurrent writes add up.
- **Storage location:** the cached downloads live in the `data\temp` folder beside `sak_utility.exe`.

## Related guides

- [Flash an ISO or disk image to a USB drive](https://sakutility.com/wiki/flash-iso-to-usb)
- [Build a Windows ISO from UUP dump](https://sakutility.com/wiki/build-windows-iso)
- [Where S.A.K. Utility stores its settings](https://sakutility.com/wiki/where-settings-are-stored)
