Save a network diagnostics report

Save the results of the network diagnostics you ran as an HTML or JSON report, with technician, ticket, and notes, using S.A.K. Utility.

To save a network diagnostics report, use S.A.K. Utility: go to the Network Management tab, open Network Diagnostics, and press Generate Report... at the bottom right. It asks for a technician, ticket number, and notes, then where to save. The report holds the results of the tests you ran in this session.

When to use this

  • You want a record of what you tested, to attach to a ticket or give to a customer.
  • You want the results as JSON, to read with another tool.

What you need

Run the tests you want in the report first, such as ping, DNS, port scan, or a speed test. No administrator rights are needed.

Steps

  1. Run your tests. Wait for them to finish.
  2. Press Generate Report....
  3. Fill in Technician, Ticket #, and Notes. All three can stay empty.
  4. Press Save.
  5. Choose a folder and a name, and press Save. The type follows the name: a .json name writes JSON, and anything else writes HTML. With no extension the file gets .html.
Generate Network Report window with Technician, Ticket number, and Notes boxes, and Save and Cancel buttons
Generate Report... asks for these before it asks where to save

How it works

The report holds what the tests on this tab found since S.A.K. Utility started. A section appears for each test that produced results. A test you ran that produced nothing, because it failed or was stopped, is marked as not run, so a gap in the report is never mistaken for a clean result.

For a speed test, the report gives the download and upload speed and the latency, or says the latency is unknown. For an iPerf3 test, it gives the speeds with the jitter and packet loss.

Good to know

  • While a test is running, Generate Report... asks you to wait for it to finish.
  • The report covers this session only. Results are gone once you close S.A.K. Utility, so save the report first.
  • It is separate from the Scan Report on the Benchmark and Diagnostics tab, which covers hardware scans.